GRASS VALLEY KAYENNE - Timeline Event Information and Work Buffer Values; Prepare the External Device for Control

Kayenne/Karrera/GV Korona
User Manual
229
Timeline Event Information and Work Buffer Values
The Device Summaries and Current Device data pads update to show the current state of
the work buffer by displaying what events exist on each keyframe as it is encountered
during effect run or time cursor navigation and showing what events will be added to the
timeline if a new keyframe is inserted or one is modified. This is consistent with other work
buffer parameters, but requires some discipline when working with events. For other
parameters, inserting keyframes without changing values will result in no change between
keyframes. But for events, this same practice will result in reissuing the event at each
keyframe. It is a good practice to use the
Clear All Events or Clear Delegated Device Events
button after inserting or modifying a keyframe containing external device events. This
prevents those same events from being duplicated when the next keyframe is inserted.
Prepare the External Device for Control
1 Turn on the EXT DEV button in the E-MEM & Timeline, Recall Run menu (or whichever
button your machine control device has been associated with) and press the
EMEM
Edit
button in the Master E-MEM Module.
Note: Devices can be assigned to any level, including 1-8 which are
provided as hard buttons in the Master E-MEM Module, in the User
Setups, Suite Prefs, E-MEM Prefs, Name Misc. Levels menu.
2 Go to the Devices, Enables menu, and select the device you wish to enable in the
Device Enables pane (left), and select the
Enable Selected button (or enable all using
the
Enable All button) in the Enables pane.