Device Control
Local Aux Module
236
Configure an External Device for XPression Control
You can configure up to four XPression devices; GFX 1-GFX 4, allowing you to send
commands from the Control Panel or menu to your external device. You can take IDs, fire up
to four GPI sets, clear buffers, and override or fine tune the controls.
1 Select
Eng Setup, Ports & Devices, External Devices in the menu.
2 In the External Devices pane, scroll down until GFX 1-GFX 4 is displayed and select one.
3 Enable the
XPression Type button
4 Select the
Device Name data pad, enter a name using the pop-up keypad, and select
Enter.
5 Select the IP Address data pad and enter the IP Address of an XPression device in the
pop-up keypad and select
Enter.
Take XPression IDs from an External Device
The Standard GFX workflow allows you to take IDs from an external XPression device then
take the next IDs in the list. Functions are also provided to clear the active buffer and all
buffers.
1
Select Devices, GFX in the menu.
numbered 1 through 16. For example, GV Device-10.
To Next Page
Loading...
