GRASS VALLEY KAYENNE - Learn a Q-MEM Register with a Single Device; Learning a Q-MEM Register with Multiple Devices

Device Control
Karrera Device Control
248
CS-1
12
345 MISC4
I ØØ:ØØ:ØØ:ØØ OU ØØ:ØØ:ØØ:ØØ
D ØØ:ØØ:ØØ:ØØ TC ØØ:ØØ:ØØ:ØØ
GV/BrightStar
K2-1 K2-2 K2-3 K2-4 CLR
CS-1 CS-2 CS-3 CS-4
TC In Out
IS 1 IS 2 IS-3 IS 4
IS 5 IS 6
ENT
In
Jog
For each device, the following device state data is learned into the cue:
• Clip name,
• Mark-In point for clip,
• Mark-out point (may be empty),
• Loop flag,
• Gang flag, and
• A list of ganged devices.
Recalling a cue register can be used to:
• Associate devices with the lettered buttons only, so you can set up your DCM for
manual use,
• Recall and cue devices without affecting the current letter button selections, and
• Both associate the devices with letter buttons and load, cue, and play them.
Device Select
(Turn to Scroll)
Clip
Select
(Turn
to Scroll)
Device Control Module, Q-MEMs
Learn a Q-MEM Register with a Single Device
To learn a simple cue with one device:
1 Select a device by pressing a control button, A - F.
2 Select a clip on that device using the bottom soft knob and press the
Load button to
load the clip. You can then set the mark-in/mark-out points (
Mark In/Mark Out buttons)
and optionally turn on the
Loop button (tallies blue).
3 Pre
ss the LRN button.
a Optionally, press the
Play button (flashes green) to add a play command (so when
the cue register is recalled, the clip will load and play).
4 Press the desired Cue register number button (use the Page and Bank buttons for the
higher numbered registers). The selected Cue register button high tallies red.
Learning a Q-MEM Register with Multiple Devices
8623267_22