Kayenne/Karrera/GV Korona
User Manual
249
Lettered button (A - F) links can be learned as part of a Cue register for later recall.
1 Press and hold down the letter buttons for the devices to be linked (for example A, B,
and D).
2 Press the
Link Cue button (high tallies blue).
3 Learn the Q-MEM register.
4 Press the LRN button.
a Optionally, press the
Play button (flashes green) to add a play command (so when
the cue register is recalled, the clip will load and play).
b Press the Cue Register button to recall the cue.
Note: To see the link cue status, press the lettered button then the Link
Cue button.
Learning Additional Devices
You can link multiple devices in addition to the devices associated with the lettered buttons
using the Cue Device Selection menu. Each clip will need to be setup with mark-in/out
points etc. prior to creating the link.
Device Control Module, Cue Links
Hold down a lettered button (A - F) and press the Link Cue button (high tallies blue), the
Cue Device Selection menu is displayed. Press the device buttons to add (or remove)
devices as part of the cue then press the
ENT (or Link Cue) button. All device buttons added
to the cue will tally blue.
Pressing the
CLR button clears all devices from the cue.
Note: Both loop cue status and link status are always learned into the
cue; if the
Loop button is high tally, then a loop is learned and if Link Cue
button is high tally blue, then the multiple devices are linked into the cue.
When recalled, a clip will load and cue for each device linked into the Q-MEM register.
(There is one Play command per register so if learned as part of a Cue register, all devices
will play when the register is recalled.)
I ØØ:ØØ:ØØ:22 OU ØØ:ØØ:Ø7:24
D
ØØ:ØØ:Ø7:Ø2 TC ØØ:ØØ:ØØ:ØØ
To Next Page
Loading...
