Device Control
Karrera Device Control
250
Learn Device Associations (only) into a Register
Cues can be used to associate devices to lettered buttons only, without learning clip and
mark information. So on recall, the devices are assigned to the lettered buttons but nothing
is done to the current status of the devices. The Cue Device Selection menu is used to
configure these associations.
1 Hold down a lettered button, and press the Link Cue button. Both the letter button and
the button for the device high tally.
2 Turn on any other letter buttons, but turn off the device buttons. If the letter button is
on and the device button is off, then only the device association will be learned into the
register.
3 Press
ENT to end the device selection and then learn a cue.
Only the association of the device to the lettered button is learned.
Learning Clips for Devices without Affecting Letter Button Associations
To learn a cue that recalls only device states for the clip, cue to mark, loop, and play but
does not affect the association of the devices with the DCM:
1 Hold down a lettered button, and press the Link Cue button. The letter button and the
button for the device are both high tally.
2 Add devices to be linked into the register, but turn off any lettered buttons associated
with the device.
Note: Without the letter buttons being learned, a recall of the register
will control the specified devices but not affect what is currently
happening on the DCM.
3 Press ENT to end the device selection and learn a cue.
About Cues and Ganging
If a device which is learned into a cue is ganged to another device, then that gang
association will be learned into the register too. So that when the register is recalled, the
devices will be ganged.
Status Display
For a selected device, the display will show:
• Device name,
• Preset or current Page/Bank,
• Last recalled page, bank, and register,
• E-MEM level name,
• Timecode,
• Mark-in/out timecode,
• Calculated duration between mark in and mark out, and
To Next Page
Loading...
