Kayenne/Karrera/GV Korona
User Manual
255
The Router Destination pane on the left is a scrolling list of switcher sources (only sources
configured as routed GV Switcher sources appear). Each button displays the Switcher
Source ID number, Destination, and Source. The currently selected switcher source on the
list is colored light blue.
Refer to the Kayenne/Karrera/GV Korona Installation & Service Manual about configuring the
Router Ethernet connection.
The Router Sources pane on the right is a scrolling list of all the available router sources.
Communication with an external routing system is required before router sources will
appear on this list. The router source button of the currently selected switcher source is
automatically selected.
Change the Router Source of a Switcher Source
1 Select the desired switcher source button in the left pane. Its current router source will
appear selected in the right pane.
2 Select a different router source button in the right pane, scrolling the menu if
necessary. The source change will be immediately enacted.
Router Source
Keypad Selection
The Router Source data pad at the top of the right pane provides access to router sources
by name. Selecting this data pad opens an alphanumeric keypad, into which you can enter
the name of the desired router source. The Router Source list will then scroll to and select
that router source, changing that source’s output signal. If an exact match is not found for
the name entered, no change will occur.
Protection
The Router Protection pane (middle) provides protection controls. These controls are used
To Next Page
Loading...
