Device Control
Camera Operations
264
When installed and configured, the GV Switcher sends tally over Ethernet to cameras. This is
described in the Installation & Service Manual for your switcher model. In addition, the
Red,
Yellow, and Green buttons in the Source Ops, Cameras menu allow you to test the camera
tally colors and/or send a call to the camera operator.
About Scene Files
Up to four Scene Files can be saved and quickly loaded to selected cameras with the Fast
Recall
(1-4) buttons or recalled as part of an E-MEM, using the Scene File in E-MEM (1-4)
buttons, in the Source Ops, Cameras, Scene Files menu tab.
Scene File Fast Recall allows you to recall scene files 1, 2, 3, or 4 to all selected cameras in the
Camera Source list. Simply select a camera source or sources and select a Scene File Fast
Recall (1-4) button.
For Scene Files in E-MEM, the Camera level button is in the User Setups, E-MEM Prefs menu
and can be used to assign camera sub-levels to levels (and are definable) and recalled as
part of an E-MEM. E-MEMs can be used for example so the TD could recall and turn off a Star
Filter on all cameras instead of it being an engineering task.
1 Select a camera source or sources in the Camera Sources list.
2 In the Scene Files menu, select the numbered
Scene File in E-MEM (1-4) button for the
scene file you wish to save as part of an E-MEM.
3 Se
lect the Enable button (highlights blue when on). EM (for E-MEM) is displayed in the
selected camera’s button data.
4 Select
User Setups, Suite Prefs, E-MEM Prefs, Cameras.
5 Select the level to which you wish to assign the Camera’s sub-level and select
Done.
6 Build an E-MEM recalling the level with the camera sub-level assigned.
The enabled Scene File will be recalled for the selected cameras.
To Next Page
Loading...
