GRASS VALLEY KAYENNE - Set the Effect Dissolve Rate for Auto Recall in an E-MEM Register; Change Path Control Values in an Effect

Advanced Operations
Building Keyer E-MEM Transitions
280
Recall.
3 Press
LRN, Auto Recall.
Set the Effect Dissolve Rate for Auto Recall in an E-MEM Register
Set the dissolve rate to seconds, frames, or fields; for example entering 1.0 results in a one
second dissolve rate where entering 10 results in a 10 frame dissolve rate, and entering .01
results in a one frame dissolve rate.
1 In the Master E-MEM Module of the Control Panel, press
LRN, DIS, RTE.
2 Press the buttons under the keypad numbers to select seconds, frames, or fields for the
dissolve rate and press
ENT.
3 Press the button for the register you wish to apply the effect dissolve rate.
Change Path Control Values in an Effect
Path control determines how interpolation is performed through keyframes. S-Linear,
Linear, and Curve path types are supported, in addition to Path Hold. These path types
provide fine control of the dynamics of the effect. See for background information.
1 Move to the location in the effect that you wish to change.
2 Go to the Path menu (E-MEM & Timeline, Path) and delegate the desired Level(s),
Sub-level(s), and Group(s). In the following example, the keyer wipe of Keyer 1 of M/E 1
has been selected for path control editing.
3 Choose the desired Path type (S-Linear, Linear, or Curve). If Curve is selected, you can
use the soft knobs or data pads to change the values for
Tension, Continuity, and Bias.
4 Add the new values to a keyframe in the effect with
Insert or Modify, or Learn. You
must change the keyframe, because current work buffer values are overwritten during