GRASS VALLEY KAYENNE - Building Keyer E-MEM Transitions

Kayenne/Karrera/GV Korona
User Manual
283
Note: Performing the transition is not required (pressing Cut
accomplishes the same goal, which is to put the switcher into the next
desired state). The transition type button selection and the keyframe
duration determines how the transition will be performed when the
effect runs.
7 If there will be another transition immediately following this one, select on the B bus
the source that will transition to in the next keyframe. This prevents undesirable
background cuts from occurring.
8 Press
Insert After to add this keyframe to the effect.
9 Repeat the steps above for any additional background transitions.
10 Rewind and run the effect to check its operation. The transitions will occur as
programmed.
11 After the effect runs properly, you can go back and modify keyframes with Source
Holds where needed.
TIP: If unwanted background cuts occur, go to the keyframe where the
cut occurs, identify the source selected on the A bus, go to the
previous keyframe, select that same source on the B bus, and then
press
Modify KF to properly setup that source in that keyframe for that
next transition.
Building Keyer E-MEM Transitions
Individual keyers transition on or off (there is no keyer preset bus). To cross fade between
keys, use two keyers and have one key transition in while the other transitions out. You can
include any combination of keys in a single transition, using the transition rules to
determine the exact behavior of the transitioning keys.
1 Go to the keyframe in the effect where you wish the key transition(s) to begin.
2 Select the
Key 1,2, etc. next transition button(s) for the keyer element(s) involved.
Selected keys that are on will transition off, and keys that are off will transition on.
3 Se
lect the type of transition (Mix, Wipe 1, or Wipe 2).
4 Press Modify to change the keyframe to the values set above.
5 Change the on/off state of the keys you wish to transition.
6 If you are transitioning in a new key, select the source on that key bus. If you are
transitioning out a key, do NOT change the source selected on the key bus for that
keyer (this prevents an unwanted cut).
7 Press
Insert After to add this keyframe to the effect.
8 Repeat the steps above for any additional keyer transitions.
9 Rewind and run the effect to check its operation. The transition(s) will occur as
programmed.