Advanced Operations
Split Layered Mode
322
Partition Sync Mode
Partition Sync mode (Sync Pri/Sec buttons) synchronizes or “locks” the chained background
transitions together and puts the Lever Arm in a primary transition-only state, with the
secondary transition attached. If you perform a Primary and Secondary transition without
Partition Sync on for a split M/E, the two outputs may be slightly offset. Turning on a
SyncPri/Sec button precisely synchronizes the backgrounds for transition.
There is no general need to chain the primary and secondary partitions of an M/E, this can
be done by selecting both the Pri and Sec buttons in Split Mode.
Partition Sync
Partition Sync selects the M/E’s Primary and Secondary partition. The Pri button high tallies
red and the Sec button high tallies green to indicate this mode. Without using Partition
Sync, there is no way to lock the Pri/Sec mode on, so if you have a Program Clean Feed set
up on Primary and Secondary partitions for re-entry, and you forget to turn the Pri/Sec
mode on for that M/E, upon transition the secondary partition would not re-enter as a clean
feed so the Program Clean Feed would be lost.
Operations
Background and Key Chaining and Partition Sync are configured in the Menu Panel.
To Next Page
Loading...
