Advanced Operations
Copying Between Transition and Key Wipes
340
Copy a Key wipe to a Key wipe
1 Select the ME and Key Wipe (Key 1 - Key 4) button in the From panel.
2 Turn on or off the
Mattes button: On highlights green.
3 Select an ME and Key Wipe button in the To pane, and if desired, choose a
Preset Patt,
Inhibit Mask, or Force Mask button to copy parameters from/to.
4 Select the Copy button.
Copying Between Transition and Key Wipes
If the keyer (to) is using a complex generator, you can choose which complex wipe will be
the destination. The complex wipe generator will be copied and the keyer will be assigned
to that generator. The generator is also assigned to the transition wipe (in most cases) and
the generator for that transition wipe is also changed. If the Keyer is assigned to a keyer
wipe, only a subset of the complex wipe parameters will be assigned.
Copy a Transition Wipe to a Keyer Wipe (and Vice Versa)
1 Select the ME and Primary (Pri Wipe 1 or Pri Wipe 2) or Secondary (Sec Wipe 1 or Sec
Wipe 2
) wipe button in the From panel.
2 Turn on or off the
Mattes button: On highlights green.
3 Select an ME and Key Wipe (Key 1 - Key 4) button in the To pane, and if desired, choose
a Preset Pattern, Inhibit Mask, or Force Mask button to copy parameters from/to.
4 Se
lect the Copy button.
Copying from a Key Wipe to a Transition Wipe works the same, however Keyer wipe values
will be copied to the Transition Wipe, not the Wipe Generator.
Copy an eDPM Wipe
eDPM Channels can be copied from one to another and between Transition and Key Wipes.
eDPM Wipes are simple wipes, similar to the Key Wipes.
1 Select the
eDPM button in the From or To pane.
2 Select a channel button (
CH 1 - CH 4) with the parameters you wish to copy from or to,
and if desired, choose a
Preset Patt, Inhibit Mask, or Force Mask button to copy
parameters from/to.
3 Select the
Copy button.
To Next Page
Loading...
