GRASS VALLEY KAYENNE - Copy;Swap with the Multi-Function Module; Copy an M;E

Advanced Operations
Copy/Swap with the Multi-Function Module
346
Copy/Swap with the Multi-Function Module
Use the Copy and Swap mode buttons in the Multi-Function Module to enter those modes
and copy or swap ME, Keyer, and e-DPM settings between M/Es.
The Wipe, Matt, and DPM buttons can be turned on and off (default is on) in the MFM. With
an ME and Keyer selected in either Copy or Swap menu delegations, the buttons will be
available therefore you can include/exclude those parameters from the copy/swap
operations.
Copy Swap—Multi-Function Module
Copy an M/E
In Copy or Swap mode, the M/E/Keyer/e-DPM sources are selected from the source buttons
in the top two button rows in the Multi-Function Module and destinations are selected in
the bottom two rows.
Note: M/E Keyers can be copied/swapped with e-DPM channels and vice
versa.
Swap M/Es
1 From the Home mode in the Multi-Function Module, press the Copy button.
2 Select the Source ME/Key.
3 Select the Destination ME/Key.
4 Press the
Copy button (below the joystick).
1 From the Home mode in the Multi-Function Module, press the Swap button.
2 Select the Source ME.
3 Select the Destination ME.
4 Press the Swap button (below the joystick).