GRASS VALLEY KAYENNE - Create a Movie from Continuously Streaming Video with Loop Mode; Create a Movie Including a Delay with Delay Line Mode

Kayenne/Karrera/GV Korona
User Manual
373
defined duration have been recorded into the buffer.
When recording in Delay Line mode, Image Store buffers video of a set duration. The
buffered video is captured from the currently recording frame back to the first frame of the
defined duration; previously recorded frames are discarded as new ones are recorded.
When recording is stopped, the buffered video is available as an Image Store movie.
Create a Movie from Continuously Streaming Video with Loop Mode
Create a movie of a set duration from the last seconds of a continuously streaming video. In
Image Store Loop record mode, the last frame of the buffer is displayed in the output.
1 In the Image Store, Images, Movie Record menu, select an Image Store channel (1/2
through 9/10).
2 Select a source for the video stream on the Image Store channel.
3 Set the record mode by selecting the
Record (mode) data pad and choosing Loop in
the pop-up Record Mode Button pane.
4 Select the
Record Mode Duration data pad, enter a duration (MM:SS:FF) in the pop-up
keypad, and select
Enter.
5 Optionally, select the Record Elements data pad and select from Video, Key as part of
the recording, then select
Done.
6 Se
lect the Timecode data pad and enter a duration in the pop-up keypad for the movie
length you wish to record, and select Enter.
7 Select
Show E-E (changes to Record) then Record.
8 Select the
Record button again to stop recording.
9 To save the recorded movie, select Keep then Enter in the pop-up keypad (optionally
you can change the image number using the keypad).
Result: An Image Store movie is created and the thumbnail is displayed in the scrolling
images list.
Create a Movie including a Delay with Delay Line Mode
Create a movie of a set duration from the last seconds of a continuously streaming video
with a delay. In Delay Line record mode, the first frame of the video in buffer is displayed in
output, therefore the frames up to the end of the recording are delayed.
1 In the Image Store, Images, Movie Record menu, select an Image Store channel (1/2
through 9/10).
2 Select a source for the video stream on the Image Store channel.
3 Set the record mode by selecting the
Record (mode) data pad and choosing Delay Line
in the pop-up Record Mode Button pane.
4 Select the
Record Mode Duration data pad, enter a duration (MM:SS:FF) in the pop-up
keypad, and select
Enter.
5 O
ptionally, select the Record Elements data pad and select from Video, Key, as part of
the recording, then select
Done.
6 Select the
Timecode data pad and enter a duration in the pop-up keypad for the movie
length you wish to record, and select Enter.
7 Select
Show E-E (changes to Record) then Record.
8 Select the
Record button again to stop recording.