GRASS VALLEY KAYENNE - Adding a New Audio Element with Build Edit

Advanced Operations
File Operations
398
Make the Sub-Clip
Select the Make Clip button.
Enter the name of the new clip and select
Enter.
The new clip is created and appears in the clip lists in the ClipStore menus.
Note: If Multiple sub-clips are desired from a built clip, use Build Edit to
make the whole clip and then use the Cut Edit to make multiple sub-clips.
Adding a New Audio Element with Build Edit
If you require audio before or after video, a video track (for example of black) is needed so a
mark can be made (this can be added with Join Edit, see Join Edit on page 484).
In this case, use the Video and Key of the loaded Video track but add/replace the Audio
track and make a sub-clip. The Use Key From Video button is enabled (highlighted green):
Add an Audio Element
In the Video area:
1 Unless the desired clip is loaded, select the
Video Thumbnail Viewer.
2 Select the Change Clip button for the Video area (top) and select the desired clip.
3 Determine where you want a mark-in point for the Video track by either
playing/jogging to the mark while viewing the clip on a monitor and selecting the
Mark In button or if you know the timecode, select the Mark In data pad and enter the
timecode into the pop-up keypad, and select
Enter.
4 Determine the mark-out point for the Video track and enter it as described for Mark In.