Kayenne/Karrera/GV Korona
User Manual
49
About Default Keyframe
Default Keyframe settings are applied when an empty register is recalled and when the
CWB (Clear Working Buffer) button is pressed in the Master E-MEM (EMEM Edit, CWB
button) of the Control Panel.
• SPOP (Single Press) clears the working buffer of enabled levels to Default Keyframe,
however it does not clear the source memory.
•
DPOP (Double Press) clears the working buffer of enabled levels to Default Keyframe
and clears the source memory to the default settings for sources selected on enabled
levels.
The Default Keyframe menu is used to learn the current Control Panel state to the system’s
Default Keyframe (and to set the Default Keyframe back to factory settings). Individual
settings for each M/E are stored in the Default Keyframe, so different states can be saved for
different M/Es, if desired.
Note: Individual Default Keyframe settings are saved for each GV
Switcher M/E.
Learn a Default Keyframe
1 Select User Setups, Suite Prefs, E-MEM Prefs.
2 Setup the Control Panel to the desired state.
3 Press the
Learn button in the Default Keyframe pane.
Note: Individual Default Keyframe settings are saved for each M/E.
To Next Page
Loading...
