Kayenne/Karrera/GV Korona
User Manual
59
Create a Show File
1 Select File Ops, Show Files.
2 Select the Create Show button in the Show Create & Load pane.
3 Select the
Show Name data pad, type a name for the Show file in the pop-up keyboard,
and select Enter.
4 Optionally, configure the show granularity:
a In the Create Show pane, select the buttons to enable or disable preferences and
settings; a highlighted green border means that area of the system will be included
in the new show.
b Select a register data pad and enter values using the pop-up keypad.
TIP: Use the register data pads left of the load granularity buttons to enter
a series or range of registers as part of the load (the default is all).
CAUTION: : The Eng Setup button (lower right of menu) is off by default
because ports and server IPs are unique. Transferring Show
files from one location to another (including suites) requires
careful planning to prevent interruption.
To Next Page
Loading...
