Suite Preferences
About Show Files
62
Update a Show File
1 Select File Ops, Show Files.
2 Select the Show file from the System or Remote Storage menu tab (left side of menu).
3 Select the Update Show button in the Show Create & Load pane to bring up the Create
Show pane that allows you to see what preferences and settings are enabled.
4 Optionally, in the Create Show pane, enable or disable preferences and settings or you
can enable the
Select All button (e-DPM is an option, if not installed the button will be
inactive).
5 To change the registers loaded, select the register data pad (left of each button) and
enter a series or range of registers to be included in the Show file (the default is all).
Note: A best practice is to set register ranges to all each time there is an
update (e.g. E-MEM 0-999, Macro 1-999, etc.), this will ensure that new
registers are included.
6 Select the Update button in the Update Show pane.
CAUTION: : The Eng Setup button (lower right of menu) is off by default
because ports and server IPs are unique. Transferring Show
files from one location to another (including suites) requires
careful planning to prevent interruption.
To Next Page
Loading...
