GRASS VALLEY KAYENNE - Set Keyer Priority; Transition between Different Keyer Priorities

Kayenne/Karrera/GV Korona
User Manual
83
The ME Status display in the Transition area shows the source names of any key cut signals.
Note: Split Key will be shown in the Modifier area Control Panel Display.
Set Keyer Priority
The GV Switcher system has four or six keyers per M/E so complex stacking is possible. Keys
can be placed between other keys, using key priority.
Note: You can also apply the following to the Keyer Secondary Priority Stack
when an M/E is in Split Mode.
1 Select Keyer, Priority.
2 If not already set up, turn on the desired keys and arrange them so they overlap,
observing the Program monitor. This will make the changes in key priority visible. For
demonstration purposes, you can use four preset pattern keys.
3 Select the keyer you wish to move in the stack in the Current column, then use the
Top,
Move Up, Move Down, and Bottom buttons on the left to place the key in the desired
location. The key priority order changes immediately, as a cut.
Transition Between Different Keyer Priorities
Key priority transitions use a Current priority stack and a Next priority stack. The transition
occurs between the two stacks.
Note: You can also apply the following to the Keyer Secondary Priority Stack
when an M/E is in Split Mode.