Video Mix/Effects
About Key Store
84
1 Press the Key Prior Transition Element button on the Control Panel.
2 If not already set up, turn on the desired keys and arrange them so they overlap,
observing the Program monitor. This will make the changes in key priority visible. For
demonstration purposes, you can use four preset pattern keys.
3 Delegate that M/E for preview in the Preview button group on the System Bar. This
shows the end result of the transition (the Next priority).
4 Go to the Keyer, Priority menu by pressing
Keyer, Priority on the Control Panel or
selecting
Keyer, Priority in the menu.
5 The current stack in the menu is automatically set to what is currently being output.
You can change the Current priority stacking order if desired, as described in Transition
Between Different Keyer Priorities, on page 83.
6 Set up the Next priority stacking order, selecting the keyers in the Next column and
then using the
Top, Move Up, Move Down, and Bottom buttons. The new stack will be
visible on the preview monitor.
7 Select the type of transition, using the Mix, Wipe 1, or Wipe 2 transition buttons on the
Control Panel. If you selected a wipe, go to the Wipes menu by double pressing one of
the
Wipe buttons, and then select the pattern and any modifiers to be used with the
wipe.
8 Move the lever arm or press the
Auto button in the Transition area to perform the key
priority transition. The transition is shown on the Program monitor.
About Key Store
Key Store is available on six-keyer systems only. Each keyer can store two frames of
memory; each frame containing both Keyer Video (fill) and Key (cut), that together create
the Key Store.
To Next Page
Loading...
