Kayenne/Karrera/GV Korona
User Manual
87
2 Select the P1 pattern to be used by selecting the Wipe Pattern button between the
Pattern Mix and Generator/Border data pads, and then selecting one of the displayed
patterns in the Pattern tab on the right.
3 Select the Pattern Mix data pad, this switches the Pattern tab on the right to the other
generator; in this case P2 (to select the base wipe pattern again, select the
Wipe
Pattern
button).
4 Select the Mix data pad located below the Pattern tab. Additional control buttons will
appear at the bottom of the menu.
5 Delegate that M/E for preview in the System Bar.
6 Press the
Trans PVW button in the Transition area, and move the lever arm part way.
This will display the P1 pattern on preview.
7 Select the delegation button in the Pri Wipe 1 column to delegate the menu to control
the Pri Wipe 1 pattern generator.
8 Select the
Pattern Mix button so its indicator illuminates. The preview monitor will now
show the combined Mix 1 and Mix 2 pattern.
9 You can select the type of pattern mix with the Mix type buttons (
Mix, NAM +, NAM –).
The NAM buttons are used for And or Or pattern mixing.
10 You can also adjust the amount each wipe pattern contributes to the mix with the
Ratio
control. At 50%, each pattern contributes equally. At 25%, the other pattern contributes
only 25% to the final pattern.
Source Memory
Source Memory is a GV K-Frame XP system feature that can be used to retain keyer settings
for each source on each keyer bus. Source Memory permits the operator to, for example,
hot cut from one source to another on that keyer bus and automatically restore different
settings learned for each keyer source.
To Next Page
Loading...
