Video Mix/Effects
Clear Transforms
100
turn off transform interpolation and hold each keyframe’s values with the Path Hold select
button.
Note: Use the Path controls in the E-MEM & Timeline menu to affect all
DPM transform and effect modifiers. Path controls in the DPM menus are
only used to adjust path parameters of individual values of a transform or
effect modifiers.
All transforms except Spin apply the same path control to all that transform’s parameters.
Spin allows different paths to be specified for each axis of the transform. When Spin is
selected, the X, Y, Z, and All select buttons are activated. The selected path will only be
applied to the specified axis.
Clear Transforms
Two buttons located on the lower right side of the Enables pane of the iDPM, Transform
menu are used to clear transform settings.
Clear X-Forms – Sets all transform parameters of the delegated keyer (or global channel) to
Default Keyframe values. The transform parameters reside in the panels below the data pad
delegation matrix and do not include Crop. Multi-Functions of other iDPM settings, i.e.
Shadow, Kurl, and Lighting are not affected.
Clear All – Sets all transform parameters and all other menu settings, including Crop values,
of the delegated keyer to Default Keyframe values.
Note: Corner Pinning is a function of i/eDPM and is an advanced
operation. For operation information see About Corner Pinning.
Border Menu
The DPM Border feature provides an independently controlled border for each licensed
iDPM/eDPM, and 2D DPM. The borders are added “outside” of normal blanking. This means
that when a border is added it does not crop into the original image so a border can be
added to a full-sized image and it will not be visible until the image size is slightly reduced.
The following controls are provided from the menu for each DPM:
• Width and softness for border top, bottom, left and right side can be controlled
independently or all together,
• Color (hue, saturation, and brightness),
• Choice of square or rounded border corners (including control of the curve tension,
continuity, and bias), and
• S-Linear, Linear, Curve, and Path Hold.
DPM Borderline Menu
The Borderline menu is accessed by selecting DPM, Borderline.
To Next Page
Loading...
