GRASS VALLEY LDX 150 - 4 K Filmic Video Modes

149
LDX 150
User’s Guide
1 To select the video mode for the Live2K signal, go to Configuration > Signals >
Live2K > Mode and select <1080p> or <1080i>.
2 To select the dynamic range for the Live2K signal, go to Configuration > Signals >
Live2K > Source and select <HDR> or <SDR>.
3 To select the IP transport protocol for Live2K video, go to Installation > Media
Interface> Outgoing Streams > Live Video > Protocol and select <ST2022-6> or
<ST2110-22>.
4 Only full raster 4K is accepted — 4K with quadrants is not supported. A workaround for
these signals is to use the first 1080p 2SI-quadrant.
4K filmic video modes
Video mode:
4K23 4K25 4K29
Required
option/license:
NativeIP + UHD FilmC NativeIP + UHD FilmB NativeIP + UHD FilmB
Required
(Q)SFP module:
10G, 25G, 100G
10G, 25G, 100G 10G, 25G, 100G
Outgoing streams (Cam to IP):
Main Video:
2160p@23.98 | ST2110-20
Main Video:
2160p@25 | ST2110-20
Main Video:
2160p@29.97 | ST2110-20
Live Video:
1080p@23.98 | ST2110-20
Live Video:
1080p@25 | ST2110-20
Live Video:
1080p@29.97 | ST2110-20
Incoming streams (IP to Cam):
Ext1:
2160p@59, 1080p@59,
1080psF@29 | ST274 Annex A
or 1080i@59, HDR only
Ext1:
2160p@50, 1080p@50,
1080psF@29 | ST274 Annex A
or 1080i@50, HDR only
Ext1:
2160p@59, 1080p@59,
1080psF@29 | ST274 Annex A
or 1080i@59, HDR only
Ext2:
2160p@59, 1080p@59,
1080psF@29 | ST274 Annex A
or 1080i@59, HDR only
Ext2:
2160p@50, 1080p@50,
1080psF@25 | ST274 Annex A
or 1080i@50, HDR only
Ext2:
2160p@59, 1080p@59,
1080psF@29 | ST274 Annex A
or 1080i@59, HDR only
Ext3:
1080p@59, 1080psF@29 |
ST274 Annex A or 1080i@59,
HDR only
Ext3:
1080p@50, 1080psF@25 |
ST274 Annex A or 1080i@50,
HDR only
Ext3:
1080p@59, 1080psF@29 |
ST274 Annex A or 1080i@59,
HDR only