157
E
Installation of (Q)SFP modules
(Q)SFP modules configurations
Depending on the workflow the optical connections of the camera need to be properly
installed. This is done through internal installation of (Q)SFP modules.
Changing (Q)SFP modules
To install or exchange an (Q)SFP module proceed as follows:
• Switch off the camera.
• Use a Torx T10 screwdriver to loosen the four captive screws from the right side panel
of the camera as indicated below:
• Lift the panel by using the small recess at the left. Remove the panel. The optic cabling
and Q(SFP) module(s) become visible.
(Q)SFP module configuration: Workflow: Camera mode:
none Local/baseband mode none
1: 1x 10G SFP (or 10/25G dual-rate
SFP)
Legacy XCU modes XCU
1: 1x 25G SFP 1x Speed UHD NativeIP
2: 2x 25G BiDi SFP 1x Speed UHD with
redundancy
NativeIP
3: 1x 100G QSFP 3x Speed UHD NativeIP
To Next Page
Loading...
