5
2
Installation
Installing a (Q)SFP module
The camera is shipped without a (Q)SFP module. Before operating the LDX 150 make sure
that the right (Q)SFP module is installed that suits your transmission configuration. Refer to
Appendix E for more information about how to install (or exchange) a (Q)SFP module.
Mounting a lens
To attach a lens to the camera head proceed as follows:
• Ensure that the lens locking ring (1) is in the unlocked position (turned
counterclockwise).
• If present, remove the dust protection cap.
• Slot the lens into the lens mount and make sure that lens and camera are accurately
aligned.
• Turn the lens locking ring (1) clockwise until the lens locks firmly into place.
• Connect the lens cable (2) to the lens connector at the right side of the camera.
• Use the cable tray (3) to stow the loop of the lens cable.
To Next Page
Loading...
