GRASS VALLEY LDX 150 - Operator Files; Lens Files; Media Files; Standard Files

71
LDX 150
User Guide
+
Note
+ ☞
Note
The standard Customer Scene file is stored via the Security menu, not the Files menu. The
decision to use the factory defined file or the customer defined file as the standard file is
also made in this menu.
The Files menu enables the scene files to be stored and recalled using the store and recall
entries of the menu system. If the message NOK (‘Not OK’) is displayed, the old values are
restored.
+
Note
+ ☞
Note
If the camera is on air and a scene file is recalled, the recalled values do not become active
until the camera goes off air.
Operator files
Four operator files are stored in the camera itself (OCAM1,OCAM2, OCAM3 and OCAM4)
while more operator files can be stored on aMedia USB flash drive. These files contain
information for setting up the non-video configuration of the camera. A Standard operator
file (factory or customer defined) is stored in the camera.
+
Note
+ ☞
Note
The standard Customer operator file is stored via the Security menu, not the Files menu.
The decision to use the factory defined file or the customer defined file as the standard file
is also made in this menu.
Lens files
Lens files contain settings related to the lens configuration (e.g. white shading). Up to four
lens files (LCam1 to LCam4) can be stored in the camera.
Media files
Media files
Standard files
By default, the green Std File button on the left-front side of the camera recalls the standard
Scene file. This file contains default parameters for picture performance. A standard
Operator file can be recalled via the Files menu. This file contains parameters for the set-up
of the camera.