GRASS VALLEY LDX 86 HS - Chapter 3: Configurations; 3.2 XF Fiber Configuration

LDX 86 HS/XS HiSpeed/XtremeSpeed HD camera User’s Guide (v1.0) 29
Chapter 3 - Configurations
Chapter 3
Configurations
3.1 Introduction
To obtain an extreme speed output, the camera must be connected to an XCU 4280
XtremeSpeed XF Fiber XCU. A hybrid XF Fiber connection is used between the camera and the
XCU while operational control uses the C2IP network and units. The XtremeSpeed XCU
supplies a triple-phase XS HD signal for a recording system.
To control the configuration an OCP 400 operational control panel can be connected via the
C2IP camera control network or directly to the Base Station using a cross-over Ethernet cable.
Additionally, an MCP 400 master control panel can be connected to the C2IP network.
3.2 XF Fiber Configuration
Master Black
USB
Iris
34
F4.5
RE
LDX 5660
XF Fiber
adapter
OCP 400 MCP 400
LDX XS/HS
Series
camera head
C2IP Camera Control
Ethernet infrastructure
XCU 4280
XtremeSpeed
XF Fiber XCU
Video
Harddisk
recorder
Monitoring
output
Program output
for slow-motion
playback
Playback
controller