181
Masterpiece
User Manual
If an existing IP address exists, the user can touch the {Copy to New} button and the IP address
info will be copied across to the “New” IP address box.
Once the IP addresses for the IP Output Fin are set, touch the {Apply All Interfaces & Restart},
this has to has to be done to restart the IP Output Fin.
Flow Menu
The Flow menu allows the user to setup each individual “Spigot” IP address, Source IP address.
Each Flow needs to have a Multicast IP address and Port as well as the IP address and Port of
the source.
The number of Spigots that are available as outputs are restricted to the type of “Flow Type”
that is selected. When selecting a Flow Type settings, refer to the number of channels listed in
the “Number of IP Outputs” tables, as listed earlier in this section.
The “Links” “Primary” and “Secondary” buttons allow separate data to be added for the
Primary and Secondary Links.The IP addresses, Port numbers and Flow Types can be entered
manually, but there is a template tool which can be used to speed up the setup process. Once
the information is entered into the “New” data field, these settings are set as “Current” by
touching the {Apply Spigot} button.This has to be done for each Flow for each Spigot
To Next Page
Loading...
