182
IP Connectivity and Operation
IP Input Menus
The IP Output Flow Template allows the user to set the Multicast IP address (this is user
specific). The Source IP is the IP address of the incoming source.
When the information is input into the IP Output Flow Template, set the “Multicast Increment”
to increment by “1”, the Template tool allows an address or port number to be incremented
each time the {Paste from Template} button is touched.
For example enter the Multicast IP address - 120.14.10.01, then setting the increment to 1, then
when the {Paste from Template} button is pressed, the Multicast IP address will increment by
1 automatically. This is handy and less time consuming if the user is setting up a lot of spigots.
This has to be done for each Flow for each Spigot.
The “Spigot Status” window displays the incoming video standard.
The “Current” and “New” allow the user to copy the Multicast IP address etc. to the “Edit
Template” menu from the “Current” area and paste from the “Edit Template” menu to the
“New” area.
• Flow 1 - this is SMPTE 2022-6
• Flow 2 - this is RFC 4175
• Flow 3 - this is Audio
• Flow 4 - This is Metadata
Note: The configuration of the Spigot dictates the type of signal carried on
each of the Flows.
To Next Page
Loading...
