392
Peripherals
Peripherals - Others
Touch the {Configure...} button to display the “Protocol Config” menu.
The “IP Client” transport type is default as “IP Client” and cannot be changed. Change the
“Settings” parameter to “User” so that the “IP Client Configuration” parameters can be set, so
that Masterpiece can communicate with the Chyron server. Enter the IP address of the server,
and set the “IP Port Number on Server”, then touch the {Apply} button. In the Protocols menu,
touch the {Activate} button and the protocol is setup.
Macro Control
To allow Chyron to trigger a macro on Masterpiece, the “Macro Control” protocol has to be
setup on Masterpiece.
In the “Protocol Type” parameter, select “Miscellaneous”, and in the “Available Protocols” table
select “Macro Control” and touch the {load} button.
Touch the {Configure...} menu link button and in the Configure menu, select “IP Server” and
select the correct port number and touch the {Apply} button.
In the “Protocols” menu, touch the {Activate} button to activate the protocol.
To Next Page
Loading...
