GRASS VALLEY NV9000 - Setup Mode; Setting the Panel ID

54
Operation
Setup Mode
Setup Mode
Setup mode occurs when the NV9616 is disconnected from its network and is freshly
powered up. In setup mode, you can set or change the panel ID, identify the software
version, and perform a test of the panel’s buttons. It is in setup mode that you must initially
set the panel ID.
After a few seconds, the LCD buttons will show ‘Acquire IP Address’ on the second button
and the panel’s current panel ID on the first button. The right-hand button is designated
the menu button:
Press the menu button to proceed to the setup menu:
There are 3 submenus: panel ID entry, software versions, and panel test mode.
Press the menu button to proceed to the first part of setup which is to set the panel ID:
Setting the Panel ID
The keypad buttons on the right become enabled. Enter a panel ID (up to 8 digits):
Press ‘Cancel’ to cancel the entry or press ‘Save’ to save the new panel ID. In either case, the
panel returns to the setup menu.
NV9616 NV9616
PANEL IDPANEL ID
0 0
ACQUIREACQUIRE
IP IP
ADDRESSADDRESS
MENU MENU
PANEL PANEL
ID ENTRYID ENTRY
SOFTWARESOFTWARE
VERSIONSVERSIONS
PANEL PANEL
TEST TEST
MODE MODE
EXIT EXIT
PANEL PANEL
ID ENTRYID ENTRY
SOFTWARESOFTWARE
VERSIONSVERSIONS
PANEL PANEL
TEST TEST
MODE MODE
EXIT EXIT
PANEL PANEL
ID ID

60616061
CANCEL CANCEL SAVE SAVE
123
456
789
0