GRASS VALLEY XCU UXF Fiber Series - Setting the Camera Number

To Next Page

To Previous Page

26 XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3)

Chapter 3 - Configuration

3.2 Setting the camera number

The front navigation panel is used to display and set the camera number, to display operational

and diagnostic information and to access and navigate the internal XCU menu.

• Push and hold the Forward button [5] for two seconds until the following selection menu

appears:

• Select the Change camera number option and push the Forward button. Or push the

Back button [2] to return to the main display status.

• Use the Up [3] and Down [4] buttons to select the camera number. Push the Forward

button to confirm the settings or push the Back button to cancel the selection.

Communication

Transmission

Camera Power

Cable

PowerOn Air

XF Fiber

1 32

4 5

Graphic display Back Up

ForwardDown

SelectBack

Make selection:

Change camera number

Menu (Monitoring)

Menu (XCU Display)

OkCancel

Camera number