36 XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3)
Chapter 4 - Media Network configuration
4.2 Camera Connect
You can use the XCU menu (either via the front panel interface on the XCU or via the OCP 400
BS remote menu) to set up the Media Network but it is more convenient to use Grass Valley’s
Camera Connect application.
Camera Connect is a part of the MCP 450 Master Control PC package.
Refer to the MCP 450/Camera Connect documentation for detailed setup and configuration of
your camera control network including the MCP 450.
To configure the Media Network follow these steps:
• On the MCP 450, open the browser and acces the Camera Connect web interface:
• Enter user name and password. The default login name is admin and the password admin.
• Click Login. The Camera Connect user interface is shown.
All user entries in the Camera Connect application are case sensitive.
• Click the Configuration tab at the top op the page; a row of sub tabs appears. The
following sub tabs are used to configure the Media Network: PTP, IP Media Port A, IP
Media Port B, IP Main A, IP Main B, IP Mon\Live, IP Video In, IP Audio and IP Intercom.
Click the double arrows at the right to access more tabs:
The IP configuration tabs list only camera systems that are IP enabled.
To Next Page
Loading...