GRASS VALLEY XCU UXF Fiber Series - Media Network Setup

XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3) 37
Chapter 4 - Media Network configuration
4.3 Media Network setup
4.3.1 Media Network local ports setup
The list of camera systems is shown, sorted by camera number. Click the IP Media Port A tab:
here you can configure (local) IP addresses, subnet mask and default gateway for Media Port
A.
The indicator(s) in front of the IP addresses for port A1 and port A2 show the status of the
physical IP network connection:
☞
Note
☞
Note
A green light does not mean that there is a correct communication link between XCU and the
10 G IP device.
Refer to the “Media Network bay” on page 89 for the location of the Media Network ports at
the back panel of the XCU.
Click the camera system you want to set up. A popup window appears and you can edit the
following parameters:
Off
port is not in use.
indicates a connection between the port and a 10 G IP device (e.g. a switch)
no connection