XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3) 39
Chapter 4 - Media Network configuration
Normally, Main video is sent as a single IP stream but with uncompressed 4K the signal is split
into four (sub)streams. Refer to the “Main video in 4K uncompressed mode” on page 39 for
detailed information about configuring a 4K uncompressed Main video stream.
Click the camera system you want to configure. A popup window appears in which you can set
the following parameters:
Main Video
Enabled — selects whether the Main video is included in the Media Network stream and to
which port the stream is sent:
Port A: Main video is routed to Port A (default setting).
Port A+B: Main video is routed to both Port A and B to enable redundant network
operation. Refer to “IP Redundancy” on page 53 for more information about IP
Redundancy.
Off: Main video is NOT inserted into the Media Network stream (this is also indicated with
the indication off in front of stream 1).
Protocol — this is the transport protocol for Main video. Select either ST2022-6 (‘embedded
SDI with audio and anciliary data over IP’) or ST2110-20 (‘Video essence over IP’).
Stream 1 (port A):
Dest. IP address — the destination IP address to which the stream is sent.
Dest. Port — the destination port number for the stream.
When the same IP address is used for the Main video, Monitoring video and/or Live video
streams, the port numbers for each stream MUST be set to different values.
4.3.3 Main video in 4K uncompressed mode
The 4K uncompressed mode is only available in combination with the LDX 86N camera. Also
make sure that the camera is running in 4K video mode.
To Next Page
Loading...