GRASS VALLEY XCU UXF Fiber Series - Test Example

XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3) 55
Chapter 4 - Media Network configuration
Tip
✎
A work around for redundancy would be to receive intercom streams from a secondary
network by an IP audio interface, embed the intercom in an Ext1 (SMPTE2022-6) stream and
send this to the XCU on the primary Media network. This could be feasible if the audio/
intercom network is separated from the video network. In this case the intercom input source
should be set to "Ext1".
4.5 Test example
Below is a simple test configuration to connect two XCUs (cross-linked). All IP settings are in
unicast, no network switch is used. For test purposes, short length copper twisted pair cabling
can be used.
IP Address:
Submask:
Default GW:
Media Network Settings
IP Video Out
10.11.5.51
255.255.0.0
10.11.5.1
Main Video:
Mon Video:
10.11.5.52:1000
10.11.5.52:1001
IP Video In
Ext1:
Ext2:
10.11.5.54:1000
10.11.5.54:1001
IP Address:
Submask:
Default GW:
Media Network Settings
IP Video Out
10.11.5.52
255.255.0.0
10.11.5.1
Main Video:
Mon Video:
IP Video In
Ext1:
Ext2:
10.11.5.51:1000
10.11.5.51:1001
port 1000
port 1001
XCU 51
XCU 52
Main Video Out Mon Video Out
10.11.5.52:1000 10.11.5.52:1001
10.11.5.51
Ext1 Ext2
Port 1000 Port 1001
TP
(not used)
10.11.5.51
Main Video Out Mon Video Out
10.11.5.51:1000 10.11.5.51:1001
10.11.5.52
Ext1 Ext2
Port 1000 Port 1001
TP
(not used)
10.11.5.52
step 1 step 2
step 1 step 2
51
52