56 XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3)
Chapter 4 - Media Network configuration
4.6 IP Timing
A separate delay is available for the main video signal from the camera to the Media Network
to allow the receiver of the stream to align the incoming IP stream to the reference video. A
built-in, fixed delay aligns the IP streams roughly to reference input for each frame rate but a
custom delay allows to align the received IP stream at the destination node.
Below are schematic diagrams of the timing and delay chains in the XCU for different
situations:
4.6.1 Timing for 2K single speed video modes
In the XCU menu, go the INSTALL > TIMING menu and use the IP VIDEO OUT function to set
the delay between -5000 μs and +5000 μs.
4.6.2 Timing for 4K Tico compressed video modes
In the XCU menu, go the INSTALL > TIMING menu and use the IP VIDEO OUT function to set
the delay between -5000 μs and +5000 μs.