GRASS VALLEY XCU UXF Fiber Series - XCU Menu Reference Guide; Video Menu Settings

XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3) 63
Chapter 6 - XCU menu reference
Chapter 6
XCU menu reference
6.1 Video menu
Menu item Settings Default Level Description
Colour Bar
Colour Bar Off, On Off User 1 Turns color bar on or off (when camera signal is not
present)
Bar Type Split, Full Split User 1 Selects color bar type: Split (according to
SMPTE RP215), Full
Anylight Optimal, Good,
Fair, Poor, Extreme
Optimal User 3 When XCU is running HiSpeed or XtremeSpeed
video modes, this setting defines how flickr
reduction is applied to the camera video signal. Refer
to the camera user’s guide for a detailed explanation
of the settings.
Note 1: Only valid for XCU Universe UXF version and
in combination with HS/XS capable cameras.
Note 2: HiSpeed and XtremeSpeed are only available
at the BNC outputs, not on the Media Network.
SD Detail
Detail Off, On Off User 1 Turns SD Detail on or off
Source R, G, Y, R+G Y User 1 Selects the source for SD Detail signal generation.
Level 0..99 25 User 1 Sets overall SD Detail level: amount of detail added
to the SD video signal.
Vertical Lvl 0..99 50 User 1 Sets the level of the vertical component in
the SD Detail signal.
Noise Slicer 0..99 10 User 1 Sets the level of the Noise Slicer.
Coarse/Fine 0..99 90 User 1 Sets SD Detail balance between coarse and fine
structures (0 = coarse, 99 = fine).
Level Dependence 0..99 30 User 1 Sets the SD Detail reduction level for shadow areas.
Soft Detail Off, On Off User 1 Switches SD Soft Detail on or off. This function
reduces the amount of detail added fo large
transitions.
Soft Detail Lvl 0..99 50 User 1 Sets the maximum limit level of detail for
SD Soft Detail.