GRASS VALLEY XCU UXF Fiber Series - Audio;Intercom Menu

XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3) 65
Chapter 6 - XCU menu reference
6.3 Audio/Intercom menu
Menu item Settings Default Level Description
Audio
Audio1 Level 0dB, 6dB 6dB User 1 Selects studio attenuation level for Audio input 1
Audio2 Level 0dB, 6dB 6dB User 1 Selects studio attenuation level for Audio input 2.
Intercom
Input Source Analog, Ext1,
AES67
Analog User 1 Selects source for intercom Eng and Prod channels:
Analog = from intercom subD-connector at
backpanel of XCU (Cradle);
Ext1 = from embedded SDI audio of external video
input 1 (EXT1)
AES67 = from AES67 intercom stream of the Media
Network.
Program Source Intercom, Audio Intercom User 1 Selects source for intercom Prog channel:
Intercom = from intercom connector at back panel of
XCU (cradle);
Audio = from embedded audio.
(In case of AES67 use program input source from
audio or intercom incoming stream)
Isolate
Isolate Isolate, System System User 1 Isolate = disconnects Program and Production
intercom channels from camera head; 
System = isolate is off
Eng
Wire Mode 4wire, 2wire 4wire User 1 Selects wiring mode for Engineering (Eng) intercom
channel.
Volt/Cur drive 4wire, 2wire 4wire Service <Advanced settings>
2/4 wire 4wire, 2wire 4wire Service <Advanced settings>
Level 0dB, 6dB 6dB User 1 Selects intercom channel attenuation (only available
in 4wire mode, in 2wire mode level is always 0 dB).
Side Tone 0..99 50 User 1 Sets side tone (feedback) volume level.
Prod
Wire Mode 4wire, 2wire 4wire User 1 Selects wiring mode for Production (Prod) intercom
channel.
Volt/Cur drive 4wire, 2wire 4wire Service <Advanced settings>
2/4 wire 4wire, 2wire 4wire Service <Advanced settings>
Level 0dB, 6dB 6dB User 1 Selects intercom channel attenuation (only available
in 4wire mode, in 2wire mode level is always 0 dB).
Side Tone 0..99 50 User 1 Sets side tone (feedback) volume level.
Prog
Wire Mode 4wire, 2wire 4wire User 1 Selects wiring mode for Program intercom channel.
Level 0dB, 6dB 6dB User 1 Selects intercom Program (Prog) channel attenuation
(only available in 4wire mode, in 2wire mode level is
always 0 dB).