XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3) 75
Chapter 6 - XCU menu reference
6.5 Security menu
SDI Live Src SDR, HDR SDR User 3 Selects SDR or HDR for the SDI Out signal on
the — E — connectors when HDR is enabled on
the camera.
Note: the XDR eLicense is needed on the
camera.
SDI Live Mode Combined,
1 Phase, 2 Phases,
3 Phases
Combined User 3 Selects the method of combining the high-speed
phases for the Live signal on the — D —
connectors when XCU runs in high speed video
mode:
Combined: all phases (3 or 6) are combined to
obtain the highest signal level for live viewing.
Note: Some blurring may occur when panning or
tilting.
1 Phase: only 1 phase is used to obtain highest
sharpness but lower video levels.
2 Phases: two phases are used (only for XS (=6X)
video mode)
3 Phases: three phases are used (only for XS
(=6X) video mode)
3G Output Level A, Level B Level A User 3 Selects SMPTE 425M Level A or Level B
mapping to be used for the Main Video signal
when XCU runs in 3G (1080p) video mode.
Level A: direct mapping
Level B: dual link mapping
2SI Payload ID 2SI 2SI, 3G User 3 Selects Payload ID for 4K video modes:
2SI = 2 sample interleave
3G = (=SDQS) Square Division Quad Split
Note: this is a setting for backward compatibility
only.
SD AspectRatio 16:9, 4:3 16:9 User 3 Selects video aspect ratio for SD outputs
HDSDI LensData
Off, On
Off
Service
<Advanced settings>
Menu item Settings Default Level Description
Menu item Settings Default Level Description
Installed level User0 .. User3 User 0 User 0 Selects XCU user level.
Note: switch the unit off and on to take the changes
into effect.
PIN Code <code> — User 2 Enter a PIN code to access Service level
DeviceID Reset Exec, ... Exec Service Resets DeviceID to its factory value.
Factory Defaults Exec, ... Exec Service Resets all settings to their factory defaults.
Clear NVRAM Exec, ... Exec Service Clears Non Volatile RAM
To Next Page
Loading...