GRASS VALLEY XCU UXF Fiber Series - Media Network Bay; SFP+ Ports Layout

XCU UXF Fiber Series XF Transmission Fiber Base Station User’s Guide (v1.3) 89
Chapter 7 - Connectors and signals
7.3 Media Network bay
7.3.1 SFP+ ports layout
Link indicator
This green LED reflects the status of the physical Ethernet connection between the XCU and
the device at the other end of the Ethernet cable (typically a switch). It lights when the
following conditions are met:
– both devices are powered up;
– both devices have enabled their Ethernet ports;
– Ethernet cable is wired correctly and inserted securely at both ends and
– both devices agreed on Ethernet settings (baud rate, and full/half duplex).
Activity indicator
This green indicator flashes continuously when data is being exchanged.
Caution
Before you remove or insert an SFP+ module, read the safety information in the “Fiber-optic
transmission units” on page 8 of this guide.
Media Port SFP+ Port Network Content
Port A Port A1 Primary Media Network stream/substreams
Port A2 Primary Media Network stream/substreams (in 4K
uncompressed video mode)
Port B Port B1 Secondary Redundant Media Network stream/substreams
Port B2 Secondary Redundant Media Network stream/substreams (in
4K uncompressed video mode) or:
12G-SDI output stream (via optional convertor unit)
(Not available in 4K uncompressed video mode)
PORT
A1
PORT
A2
PORT
B1
PORT
B2
A1
B1
A2
B2
1
2
SFP+ Port
detailed view of
indicators (4x):
1
2