14 XCU eXchangeable Control Unit User’s Guide (v1.6)
Chapter 1 - Introduction
1.2.4 Camera control and monitoring
You can access the XCU menu, which contains all operational settings, from an Operational
Control Panel. In addition to the operational menu, the installation and service menus can be
accessed directly from the XCU. The XCU is compatible with all existing control system
components.
An OCP 400 operational control panel can be connected directly to the XCU using a cross-over
Ethernet cable. Full camera control is provided via a C2IP Ethernet-based control network.
The communication facilities provide for two-wire or four-wire high quality intercom signals.
Transmission quality can be continuously monitored before and during operation from the
OCP
400 operational control panel and/or the Connect Gateway.
To Next Page
Loading...