214
Program description - Free mixers
L.Mix 1
0%
Offset
ASY
SYM
9 1
Mix input
+25%
+25%
However, you should also de-couple the assigned
transmitter control from control channel 9, so that
any servo which may be connected to receiver
output 9 can no longer be operated by this trans-
mitter control. This is accomplished in the »Mix-
only channel« menu, see page 216, which
is available as standard on the mc-20 HoTT
transmitter only, but can be unlocked on the mc-
16 HoTT transmitter at extra cost.
To Next Page
Loading...
