GRAUPNER MC-28 - Telemetry Data Display; Sensors

33 / 80
33028_mc_28_Teil2_jh
The control curve is defined by up to 6 points (points of intersection)
along the entire control stick path. The graphical representation
shows how the support points are set and adjusted.
In the first line, the effect of the curve function can be switched "on"
or "off".
The "Input" and "Output" lines are only displays. The values indicate
the current position of the control stick "Input" and the position of
the control signal (output).
In the line "Point", the changeable points are set on the curve line.
The number (1 - 4) or the letter (L = low or H = high) after "Point"
indicates which point is currently selected. The percentage of the
current point is displayed in the field nearby.
Setting the support point step-by-step:
• Select the line "Point"
• Move into the desired position the throttle stick or the other con-
trol element for CH1
• Pressing the SET button generates a point (maximum 4 possible)
Support points moving step by step:
• Select the line "Point", activate the field with the SET button
• With the use of the buttons
t u of the left touch-pad or with
the control element select the point, "Trim point" will appear in
the second line of the display
• With the buttons
t u or  of the right touch-pad move
the point into the desired direction
Trim offset
With this function the entire curve can be moved vertically (max.
±25%). Tap on the buttons  of the left touch-pad. In the second
line "Trim offset"will appear.
The curve is automatically rounded if the function is set to "on" in
the line "curve".
Input
Output
Point
1
+50%
+50%
Ch1
Normal
curve
Curve
off
+50%
Input
Output
Point
2
+50%
–75%
Ch1
Normal
cur ve
Cur ve
off
–75%
Input
Output
Point
?
0%
–33%
Ch1
Normal
curve
0%
Trim X axis
Input
Output
Point
1
0%
+50%
Ch1
Normal
curve
+50%
Trim offset
Input
Output
Point
1
–50%
0%
Ch1
Normal
cur ve
Cur ve
0%
on