Page 20 of 49 S1024.mz-32-V2.1-EN
(Multirotor)
(Surface and Water)
Notes
• The control mode selected during setup of the transmitter is stored
as a default for models to be set up in the future. Changing the
default mode setting can be done in the "Control Mode Preset"
option of the "System Config." Submenu of the system menu.
• Within a model memory, the control mode can be also changed at
any time in the last value field of the sub-menu "Model Type" of the
basic menu.
• Depending on the choice of a control mode, one of the two control
sticks may also need to be switched to non-neutralizing, see above
under "Neutralizing the control stick".
• Not only the presetting of the control mode but also the language
setting can be adapted to the current needs in the sub- menu
"System Config." of the system menu as well as date and time in the
submenu "Clock Info" of the basic menu.
MODE 2 (Throttle/Pitch left)
Nick
Nick
Yaw
Yaw
Throttle/Pitch
Throttle/Pitch
Roll
Roll
Throttle/Pitch
Throttle/Pitch
Yaw
Yaw
Nick
Nick
Roll
Roll
Nick
Nick
Roll
Roll
Throttle/Pitch
Throttle/Pitch
Yaw
Yaw
Throttle/Pitch
Throttle/Pitch
Roll
Roll
Nick
Nick
Yaw
Yaw
MODE 1 (Throttle/Pitch right)
MODE 3 (Throttle/Pitch right) MODE 4 (Throttle/Pitch left)
MODE 2 (Throttle/Pitch left)
Nick
Nick
Yaw
Yaw
Throttle/Pitch
Throttle/Pitch
Roll
Roll
Throttle/Pitch
Throttle/Pitch
Yaw
Yaw
Nick
Nick
Roll
Roll
Nick
Nick
Roll
Roll
Throttle/Pitch
Throttle/Pitch
Yaw
Yaw
Throttle/Pitch
Throttle/Pitch
Roll
Roll
Nick
Nick
Yaw
Yaw
MODE 1 (Throttle/Pitch right)
MODE 3 (Throttle/Pitch right) MODE 4 (Throttle/Pitch left)
To Next Page
Loading...
