GRAUPNER POLARON EX-1400 - Available combinations of charge and discharge modes

English
INNOVATION & TECHNOLOGIE
28
29
C Auto Discharge current acquired from the menu “DISCHARGE”.
The discharge can therefore be adjusted as necessary
only in the menu “DISCHARGE”.
Once the settings are matching with your wishes, go to ...
Start of cycle
PM 09:02:23
CYCLE
Charge Mode
Discharge Mode
CH1 CH2
00 NiCd Auto Mode
AUTO
AUTO
Balancer port
is not connected...
00:00:00
C-D
… Tap the ENTER button on the bottom right of the display brings on the sec-
ond display page of the „CYCLE“ menu.
In parallel, the battery charger balancer checks the active channel CH1 or CH2
charge and compares the number of cells of the connected battery with the
default settings, then, if necessary, appropriate messages are shown on the
display.
PM 09:02:32
CYCLE
Charge Mode
Discharge Mode
CH1 CH2
AUTO
AUTO
00:00:00
Start Delay Time
00 NiCd Auto Mode
5
C-D
Then you have about ve seconds to change the material transferred from the
menus “CHARGE” or “DISCHARGE” and charge and discharge mode and, if
necessary, set a start delay.
Available combinations of charge and discharge modes
Battery type Charge mode Battery type Discharge mode
NiCd and NiMH batteries AUTO NiCd and NiMH batteries AUTO
NORMAL NORMAL
LINEAR LINEAR
LiFe, LiIo, LiPo batteries CC/CV LiFe, LiIo, LiPo batteries NORMAL
CV-LINK LINEAR
Pb batteries CC/CV Pb batteries NORMAL
LINEAR