37
Menu TOOLS
In this menu “Tools“ you can enter by pressing the respective icons in a Servo Test, Engine Test,
ESC Brushless Control + T and a Tire Warmer menu:
To prevent sparking when connecting the terminals of CH1 and CH2 are covered with one
capacitor, that is why the charging voltage in the line “output“ is displayed as long as no
motor is connected.
Submenu Short description
SERVO Test menu for servos and brushless motors with integrated
sensor connection
MOTOR Setup menu for brushed motors
HEATING Warming menu for tires and batteries
E.S.C. Menu for electronic speed controllers with integrated
telemetry connection cable type “Brushless Control + T”
Submenu “SERVO“
Display description
PM 06:49:16
CH1 CH2
SERVO
700
2300
1500
0.3s
1500
RPM:
0.00
V
0KV
0
....
700 2300
1500
1100
1900
1
2
3
4
7
8
9
10
6
5
1 Graphic display of the servo position
2 Servo position on the minus side in μs (range 700 ... 1500 μs in increments
of 10 μs)
3 Servo center position in μs (range 700 ... 2300 μs in increments of 1 μs)
4 Servo position on the plus side in μs (setting range: 1500 ... 2300 μs in
increments of 10 μs)
5 Sensor Check
6 Output signal resulting from most recently selected servo position (2, 3 or
4)
7 Operating time
8 Motor speed determined by the speed control
9 Output voltage / charging voltage of the buffer capacitor
10 Kilovolt-display
The “servo test” function of this submenu automati-
cally moves the servo connected to the side “SERVO
TEST” connector as if, for example, the switch of a
transmitter moved continuously and permanently with-
in the set time between its two end points.
Please check carefully the correct polarity of
the servo plug when plugging in the servos,
see gure by side!!!
If you wish to use the additional option to test Brush-
less motors with integrated sensors, connect the
control cable of the controller with the correct polarity
to the “SERVO TEST” connector. The motor sensor cable has to be connected in parallel with the
controller sensor cable to the “SENSOR MOTOR” connector of the charger:
PM 01:23:45
CH1 CH2
TOOLS
SERVO
MOTOR
WARMER
E.S.C.
S + –
yellow/red/black
or
yellow/red/brown
EX-1400
To Next Page
Loading...
