51
Other port is in use!
Motor stop
◄ The motor was stopped because the other output is in use.
Please check your parameters.
Calibration data
or internal circuit
might have been
damaged.
Calibration
◄ Errors in calibration or in the circuits of the device. If the error
message appears repeatedly, please contact the service.
Sync order failed.
Error occurred in the
counterpart channel!
◄ The cell count in the menu charge / discharge and Sync Mode
menu does not match with the detected number of cells on
Channel 1 and Channel 2.
Troubleshooting
Problem Possible causes
When connecting the
charger the display
remains dark
• Check that the external power supply meets the requirements of the
charger and that all cables are properly connected. If the problem per-
sists, contact the Service.
The charger does not
recognize the battery
• Check whether the battery is properly connected to the charge port
and the balancer.
• Check whether a cell of the battery is defective.
The battery voltage is
too low after charge
• Check whether the charge settings are correct.
• Check the set delta peak value of NiCd / NiMH batteries.
• Check the connecting cable of the battery.
Discharge mode is not
retrieved
• Check if the selected cell voltage matches the battery features.
• Check whether a cell of the battery is defective.
Battery is not fully
charged after the maxi-
mum charging time
• Charge the battery pack. Run a full cycle charge process by improving
the capacity (battery has been stored for too long or is consumed).
• Check whether in the charge cycle, the minimum discharge voltage
correctly is set.
To Next Page
Loading...
