Page 33/55
8. TYRE HEATER / BATTERY HEATER SCREEN AND POWER SUPPLY SCREEN
8-1. How to use
Using tyre warmer of GM-Racing #94711 or Much More or battery heater of Much
More. Never heat tyres over 80°C and never heat batteries over 50°C.
Insert the temp sensor into the tire warmer.
Select SETUP menu
Starting this mode.
Even changed values during operation should be also stored internal memory.
8-2. SETUP
- SET TIME 1
Set operation time 1.
When it reaches the selected operation time, operation should stop.
- SET TEMP 1
Set tire temperature 1 for the best tyre additive efficiency.
Control output in accordance with temperature.
- SET DELAY
Set the delay time between heating setting 1 and setting 2, if need for better
tyre performance.
- SET TIME 2
Set operation time 2.
When it reaches the selected operation time, operation should stop.
- SET TEMP 2
Set tire temperature 2 for the best racing temperature.
Control output in accordance with temperature.
- CURRENT LIMIT
Set max currents which is delivered to tire warmer. The max. current should
be limited to 3.0A. Current is not increased any more when it reaches max
currents even if tire temperature does not match.
8-3. POWER SUPPLY
Set the voltage limit and current limit.
Connect the user to the output and then start the power supply function
with the dial button. If you start the power supply and then connect a user,
It can happen, that the power supply will switch-off and cause a reset of the
charger.
To Next Page
Loading...
