GRAUPNER ULTRA DUO PLUS 60 - Motor Run-In Screen

Page 34/55
9. MOTOR RUN-IN SCREEN (Warning: only use DC brushed motors or DC fans!)
9. MOTOR RUN-IN SCREEN (Warning: only use DC brushed motors or DC fans!)
9-1. MOTOR Break-In
- This is motor brake in mode.
- Rotate the motor keeping the selected voltage.
- Set voltage and operating time.
- Set 0.1V~24V
Make sure not to exceed 12V when breaking in motor used for electric power.
12~24V range is for operating range of fan.
- - - - - - - - = -
MOTOR RUN
MOTOR BREAK-IN <1/3>
SET VOLT _0.0V
SET TIME __0m _0s
RUNTIME 000m 00s
VOLTAGE _0.00V
CURRENT _0.00A
Program Mode <2/3>
1st 2nd 3rd 4th
V>_0.0 _0.0 _0.0 _0.0
T> _0m _0m _0m _0m
D> _0m _0m _0m _0m
SPEED:0 CYCLE: _0
_0.00V _0.00A _0CYCLE
__0m00s -00000s
MOTOR Test <3/3>
Test voltage 0.0V
1st _0.0Aavg _0.0Apk
2nd _0.0Aavg _0.0Apk
3rd _0.0Aavg _0.0Apk
4th _0.0Aavg _0.0Apk
5th _0.0Aavg _0.0Apk
6th _0.0Aavg _0.0Apk
MOTOR BREAK-IN <1/3>
SET VOLT _0.0V
SET TIME __0m _0s
RUNTIME 000m 00s
VOLTAGE _0.00V
CURRENT _0.00A
MOTOR BREAK-IN <1/3>
SET VOLT _0.0V
SET TIME __0m _0s
RUNTIME 000m 00s
VOLTAGE _0.00V
CURRENT _0.00A
Program Mode <2/3>
1st 2nd 3rd 4th
V>_0.0 _0.0 _0.0 _0.0
T> _0m _0m _0m _0m
D> _0m _0m _0m _0m
SPEED:0 CYCLE: _0
_0.00V _0.00A _0CYCLE
__0m00s -00000s
Program Mode <2/3>
1st 2nd 3rd 4th
V>_0.0 _0.0 _0.0 _0.0
T> _0m _0m _0m _0m
D> _0m _0m _0m _0m
SPEED:0 CYCLE: _0
_0.00V _0.00A _0CYCLE
__0m00s -00000s
Program Mode <2/3>
1st 2nd 3rd 4th
V>_0.0 _0.0 _0.0 _0.0
T> _0m _0m _0m _0m
D> _0m _0m _0m _0m
SPEED:0 CYCLE: _0
_0.00V _0.00A _0CYCLE
__0m00s -00000s
... 11x