Page 42/55
j. FAST-CHG
This is only for Lilo/LiPo/LiFe battery:
CC to CV method. (CC = constant current, CV = constant voltage)
Charge finished at 20% of the adjusted charge current.
Connect the balancer wires for safety reasons.
k. CV-LINK
This is only for Lilo/LiPo/LiFe.
Same capacity batteries should be used in this mode.
CV-LINK PROCESS can be selected only after balancing cable is
connected to the balancing port of the charger.
CV-LINK is to charge simultaneously, so the counterpart output
should be not being operated.
This mode is to charge individually with the battery in series.
If 7cells battery is connected in series as two packs to be used as
14 cells. This mode is to charge individual 7 cells.
If capacity is the same, 4cells in output 1 and 3cells in output 2
can be charged separately.
If charging starts in CV-LINK mode, battery connected to the
counterpart output can be also checked automatically.
Output where charge is being operated is a master output, and
the counterpart output is slave output.
All parameters in slave output are automatically gained from the
master output, so only hardware of the slave output is used.
However, cell information in slave output is gained from the cells
which are connected at the balancing port of the charger.
After CV-LINK charge is finished, only operation data of the
master output is stored in TRACE date. Which means, the data in
Slave output is not stored because hardware of slave output is
only used
l. STORE
This is only for Lilo/LiPo/LiFe battery:
CC to CV method. (CC = constant current, CV = constant voltage)
The best store voltage can be adjusted with the ‘DIAL’ button.
(push, dial and push)
(LiPo: 3,8V, LiIo: 3,7V, LiFe: 3,4V). Connect the balancer wires for
safety reasons.
To Next Page
Loading...
